Browse Categories

Search in Category

Inserts

Search Filters

  • ISO H - Hardened Steel x
  • DMK15-GLH x

Filter Your Search

Shop by Category

Loading...

Heavy-Feed Inserts – R4 12mm IC

R4 12mm IC Heavy-Feed Inserts
R4 Heavy-Feed Insert
Insert Part Number IC Thickness # of Usable Edges Corner Radius (Actual) Program Radius* 
(Bull Nose)
DOC (Max.) DOC (Recommended)  FPT** 
(Adjusted)
RF12-T 12MM .220" 4 .094" .135" .060" .020-.050" .025-.070"
RF12-D 12MM .220" 4 .094" .135" .060" .020-.050" .020-.055"
RF12-F 12MM .220" 4 .094" .135" .060" .020-.050" .035-.080"

* A special corner radius value is required for correct programming of a high-feed insert. Using the program radius avoids gouging of the corners in the workpiece material.

**The FPT number here is already adjusted for chip thinning - use this number to calculate the IPM programmed into the machine program.

The high-feed insert will naturally leave a small amount of extra material at the bottom-most layer of the cut, at the intersection of the wall and pocket floor.

RHINO-FEED inserts are labeled with dots to indicate die position during pressing. For the most accurate runout when loaded into the cutter body, make sure each insert is loaded with the corresponding edge.

** Start with these filters – they will guide you to the right insert for your application **

ISO H - Hardened Steel X
DMK15-GLH X
Loading...
Viewing Page 1 of 1 (1 results)
Item Best For Carbide Edge Type Coating Grade Price Inventory
64192
RF-12-T-DMK15-GLH
ISO 3-Hardest (Wear Resistant) Strong 2-Slick high-temp DMK15-GLH
In Stock
Order multiples of 10 EA
64192
RF-12-T-DMK15-GLH
  • ISO
  • 3-Hardest (Wear Resistant)
  • Strong
  • 2-Slick high-temp
  • DMK15-GLH