RHINO–FEED high-performance tools

Obtain feed rates up to 5x faster than normal with RHINO–FEED high-performance tools

 

NEW Rhino-Feed Cutting Tool Videos

What is RHINO-FEED?

The ultra-aggressive geometry of RHINO-FEED, DAPRA's High-Feed line, takes advantage of chip thinning to allow feed rates up to 5x faster than normal!

Use RHINO-FEED high-feed inserts for:

How Rhino-Feed WorksHow does RHINO-FEED Work?

High-feed milling creates significant chip thinning due to an extreme lead angle. Feed rates must compensate for this to maximize productivity. The figure at right shows an example of this condition. Adjusting feed rates to account for chip thinning creates cutting conditions that provide very high feeds (IPM), but at lighter depths of cut (DOC). See the specific instructions for each size of high-feed insert below to get the most of your Dapra RHINO-FEED™ product!

Rhino-Feed High-Feed Cutter Bodies

High-Feed Cutter Bodies

High-Feed Inserts

R2 Mini-Feed Cutters and Inserts

  • .500" - 1.000" OD
  • 8mm IC
  • 3 usable edges
  • "D" cutting edge
  • .030" max. DOC
R2 Mini-Feed Cutters and Inserts

R3 Mid-Feed Cutters and Inserts

  • 1.000" - 3.000" OD
  • 10mm IC
  • 4 usable edges
  • "T," "D" or "F" cutting edge
  • .045" max. DOC
R3 Mid-Feed Cutters and Inserts

R4 Heavy-Feed Cutters and Inserts

  • 1.250" - 6.000" OD
  • 12mm IC
  • 4 usable edges
  • "T," "D" or "F" cutting edge
  • .060" max. DOC
  • Extra-strong top clamping
R4 Heavy-Feed Cutters and Inserts

NOTE: High-feed milling does a tremendous amount of work in a short period of time. This line's high production rate can create more heat than typical milling tools. Strong air blast is recommended (multiple lines if possible).

Dapra Rhino-Feed products are made in the USA.